RCU Forums - View Single Post - Custom Camera Mount

12-27-2006, 09:03 PM

#24

Sky High

Senior Member

Join Date: Dec 2005

Location: Atlanta, GA

Posts: 1,514

Likes: 0

Received 0 Likes on 0 Posts

RE: Custom Camera Mount

Well, I did have a similar issue when I first got those new motors but I'm not sure if it was the motors or not. It just quit and fell but luckily it was over grass and was only about 20 ft high. It seems like my problem is an issue with the flight board and the video transmitter board being compatible. You are right about the new motors being a bit too rigid for a spin up. I don't like how they start up or suddenly stop after landing either. Were you aware that the gold bottom has to be front or back and the silver bottom has to be left or right? According to DFI, they will work if mixed but not with maximum efficiency. It has something to do with their inner windings. I have never had any problems with the standard motors either, except for wearing them slap out!

Were you flying with or without Ti for those stills and video?

Reply Like