RCU Forums - View Single Post - ZNLine factory: Enigma Building
Thread
:
ZNLine factory: Enigma Building
View Single Post
02-06-2003, 06:21 PM
#
16
MarkNovack
Senior Member
My Feedback: (
3
)
Join Date: Feb 2002
Location: Nameche, BELGIUM
Posts: 1,552
Likes: 0
Received 1 Like on
1 Post
ZNLine factory: Enigma Building
Note the scrap. I wanted to show what was cut away. After the cutting wheel, I used a block with 80 grit on the sides and back and then 400 grit to remove the fuzz that Kevlar always leaves.
Attached Thumbnails
Reply
Like
MarkNovack
View Public Profile
Send a private message to MarkNovack
Find More Posts by MarkNovack
View iTrader Profile