RCU Forums - View Single Post - How to keep the torque from prop low?
Thread: How to keep the torque from prop low?
View Single Post
Old 05-20-2007 | 07:29 PM
  #2  
subhunter13
Senior Member
 
Joined: Nov 2006
Posts: 237
Likes: 0
Received 0 Likes on 0 Posts
From: Newport , NC
Default RE: How to keep the torque from prop low?
Range and the overload circut I have little experience in,
But if you install ball bearings that might make it less jerky ans If you have two motors
you can make them counter rotating but you would have to reverse the propeller on the modifyed one
but I have little experience in such matters, Captian Nemo, Could you Uh, Take this over.


subhunter13 is offline  
Reply Like