RCU Forums - View Single Post - Can this be cast from Inconel.. ?
Thread: Can this be cast from Inconel.. ?
View Single Post
Old 03-11-2003 | 01:48 AM
  #14  
Glorfindel
Senior Member
 
Joined: Aug 2002
Posts: 441
Likes: 0
Received 0 Likes on 0 Posts
From: Laterriere, QC, CANADA
Default Can this be cast from Inconel.. ?
Maybe it can be done by EDM, i think some of the inconel turbine wheel of our small turbine are made that way by now.

EricJ : SolidWork is not an High-end cad prog It's an entry level one, like Inventor. ProE, CatiaV5, Ideas or UG are high-end integrated cad progs
Glorfindel is offline  
Reply Like