Old 05-12-2003, 05:30 PM
  #1  
jtholley03
Senior Member
My Feedback: (4)
 
Join Date: Dec 2002
Location: Kelso, WA
Posts: 187
Likes: 0
Received 0 Likes on 0 Posts
Default Multiplex - Programming Profi 4000 for Ultra Stick 60 Part II

OK here is where I am at. Have servos 1-9 programmed as Servomix. Servos 3 and 6 unused.

Assign mixers:
Servo 1: RUDDER
is operated by:
1. RUDDER TRIM

SERVO 2: THROTTLE
is operated by:
1. THROTTLE TRIM

SERVO 4:
is operated by
1. ELEVATOR TRIM

SERVO 5: LAILERON
is operated by:
1. AILERON TRIM

SERVO 6:
is operated by:
1. UNUSED

SERVO 7: RAILERON
is operated by:
1. AILERON TRIM

SERVO 8: LFLAP
is operated by:
1. FLAP

SERVO 9: RFLAP
is operated by:
1. FLAP

How do I get servo 6 out of the mix?

My rudder and flaps don't work. I can set centers and limits for them but I don't get any response from the TX. I have Rudder set for control A and flaps set for control f.

Plane is setup with one servo for each control surface. One for L aileron, one for L flap and duplicate for the right.

What am I missing?