ORIGINAL: DanMacMurray
ORIGINAL: drdoom
It can also cause melted servo wires, Fiberglass distortion, melted air lines...
<center>
[img][/img]
</center>
note the horizontal stabs and the fact that they are not equal by 2 inches or more .
And?
If he was doing a "transmitter" start sequence, he could of just turned off the transmitter as soon as he saw what was happening which would cause the failsafe to kick in and shutdown the turbine (or starting sequence in this case)... And if on JR 2.4 if it wasn't bound after setup, that could of been how the elevators were when initially bound....