RCU Forums - View Single Post - Futaba 14mz flap question
View Single Post
Old 12-07-2009, 06:17 PM
  #4  
nxtdoor
My Feedback: (10)
 
Join Date: Jun 2002
Location: Tulsa, OK
Posts: 406
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Futaba 14mz flap question

I just went thru this. Assign to a 3-pos switch. Set your takeoff flap as the centered position of the servo. Use end point adjustments to detemine the landing flap location and flap up position. Works great.
Don't try to use ATV.
It is only a load when down. You don't leave flaps down long enough to worry about the load.

Jeff