Hey all,

SO Im building a tower trainer ARF. This is much more involved than my first ARF (nexstar). Well This one I have to make the dihedral out of the pieces of wood. Well I tried improvisins while epoxying them together and one piece moved a bit during cure time. Well not a huge issue, I could sand it down. Well after thinking about it, I always wanted to have no dihedral in my next trainer. (mind you that my nexstar was layed to rest during a mishap last year not involving myself) I feel I was doing good but wanted to lose the dihedral.

So my question is, How do I go about it at this point? DO I just cut 4 pieces of wood the same size as I had to start with but cut them straight and put them in the wing?

BTW, Did I mention the nexstar was MUCH easier to put together?