RCU Forums - View Single Post - One Design Build
Thread
:
One Design Build
View Single Post
03-28-2010, 10:40 PM
#
32
Tony Hallo
Join Date: Jan 2003
Location: Springdale, PA
Posts: 1,827
Likes: 20
Received 49 Likes on
47 Posts
RE: One Design Build
For fitting the braces I made this little tool out of two price of 3/8" spruce and a piece of 1/8" plywood scraps. The tool butts against one of the 3/8" sticks forming the angle that will receive the brace, the end extends over the joint. This allows the brace to be held and place and marked, I normally just sand to the marks leaving a little long, then slowly finish sand for a perfect fit.
Attached Thumbnails
Reply
Like
Tony Hallo
View Public Profile
Send a private message to Tony Hallo
Find More Posts by Tony Hallo
View iTrader Profile