RCU Forums - View Single Post - V-tail setup
Thread
:
V-tail setup
View Single Post
04-04-2010, 11:43 AM
#
7
Tall Paul
Senior Member
Join Date: Jun 2002
Location: Palmdale, CA
Posts: 5,211
Likes: 0
Received 1 Like on
1 Post
RE: V-tail setup
Should look like this...
First set up the elevator function so that both go up with back stick.
Set the servo polarities to do this.
Then swap channels for the servos if the turning function is reversed.
Attached Thumbnails
Reply
Like
Tall Paul
View Public Profile
Send a private message to Tall Paul
Visit Tall Paul's homepage!
Find More Posts by Tall Paul
View iTrader Profile