RCU Forums - View Single Post - Changing brick from Vapor to Ember2
View Single Post
Old 08-10-2010, 10:30 AM
  #1  
2ndjoystick
Junior Member
 
Join Date: May 2006
Location: Chevy Chase , MD
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Default Changing brick from Vapor to Ember2

While flying Ember2 outside ,after a rain shower, water got onto the brick and "shorted" a circuit on the rudder servo. Some smoke came out and the servo goes full left ONLY. I have two Vapors and want to replace the "shorted" brick with one from a good Vapor. It is NOT clear how to release the servo rods without bending them beyond use. The "brick" slides into some rails on the mount but, some "goop" holds it in. What is it?? Any help is appreciated!!