RCU Forums - View Single Post - ESM 89 in. Spitfire build!!
Thread: ESM 89 in. Spitfire build!!
View Single Post
Old 09-10-2010, 11:15 AM
  #15  
fw190
My Feedback: (37)
 
Join Date: Jan 2002
Location: Burbank, CA,
Posts: 1,418
Received 2 Likes on 2 Posts
Default RE: ESM 89 in. Spitfire build!!

ORIGINAL: R/C 4 ever

I have a few more concerns I would like to post and hopefully I will get some answers.It appears my main wing spar is too long and will have to be cut down a inch or so. Anybody else run into this or is it just me?

What is the story on the elevator cable? The book says nothing about how it connects at the elevator. I am guessing that it goes into the top hole on the controll horn and runs down to the bottom hole and back to the servo. That would make it one continues cable with two stress points on the cable where it is run through the control horn. Am I seeing this right? I perfer a servo for each elevator myselfanybody set there's up this way?

AgainThanks to all
Chuck

Same problem here, I forget how much I took down on it.

Pull-pull on the elevators for me is never going to happen... IMO I just don't trust it, two elevator servos with separate control rods, this is a giant scale.
fw190 is offline  
Reply Like