Go Back  RCU Forums > RC Airplanes > Aerodynamics
Reload this Page >

Wing-Stabilizer incidence on Ultra Stick

Notices
Aerodynamics Discuss the physics of flight revolving around the aerodynamics and design of aircraft.

Wing-Stabilizer incidence on Ultra Stick

Old 04-01-2002, 02:17 PM
  #1  
stomper
Senior Member
Thread Starter
My Feedback: (20)
 
Join Date: Dec 2001
Location: Clayton, NC
Posts: 2,249
Likes: 0
Received 0 Likes on 0 Posts
Default Wing-Stabilizer incidence on Ultra Stick

Hello All

I'm building a H9 Ultra Stick 120 and making it a low wing plane by filpping the fuselage. the incidence should be 0-0, but have found the wing to be at two degree's and the stabilizer at one degree. I have now sanded the wing saddle for the wing to sit one degree. Problem is I don't have much fuselage to cut/sand under the stabilizer. Fuselage come's to a tappered point at rear. Do you guys think both wing and stabilizer left at one degree will be a problem ? I don't know if they are out negative or positive. Both need to come down on there leading edge.


Thanks for any help
Doug

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.