Go Back  RCU Forums > RC Airplanes > Aeroworks Vendor Forum
Reload this Page >

DLE 35RA on a 35cc Extra 300

Notices
Aeroworks Vendor Forum This is the place to go for all your questions concerning anything Aeroworks. Rocco, Mark, and the rest of the Aeroworks staff will be manning this forum so that they can answer all your questions.

DLE 35RA on a 35cc Extra 300

Old 03-11-2013, 07:48 PM
  #1  
r_adical
Thread Starter
My Feedback: (19)
 
Join Date: Sep 2010
Location: Garrison, MT
Posts: 169
Likes: 0
Received 0 Likes on 0 Posts
Default DLE 35RA on a 35cc Extra 300

Mark,

have you or anyone you know tried ths combination for fit with a canister?


Thoughts?

Thanks
r_adical is offline  
Old 03-12-2013, 08:33 AM
  #2  
Mark Dennis
My Feedback: (4)
 
Mark Dennis's Avatar
 
Join Date: Feb 2004
Location: Parker, CO
Posts: 1,690
Likes: 0
Received 1 Like on 1 Post
Default RE: DLE 35RA on a 35cc Extra 300

The DLE 35 is too light for either one of our 35cc airplanes. These planes were designed around a motor that weighed what most 50cc motors weigh today.

I am sure it would fly the airplane but you would need to add a substantial amount of weight in order to achieve the proper CG.

Please let me know if you have any other questions,

Mark
Mark Dennis is offline  
Old 05-15-2013, 12:22 PM
  #3  
r_adical
Thread Starter
My Feedback: (19)
 
Join Date: Sep 2010
Location: Garrison, MT
Posts: 169
Likes: 0
Received 0 Likes on 0 Posts
Default RE: DLE 35RA on a 35cc Extra 300

Hi Mark, in the for what it is worth department I swapped my Brison 2.4 that was on the 35CC Extra straight up for a DLE35RA. I had my CG about 3/8 of inch behind factory recommendation to start with. No additional weight was necessary to keep the CG there with the DLE 35RA.

Flight testing required one click of down trim from the previous settings and performance was equivalent to the Brison or better...


No Bad Tendencies or landing issues were noted so I would say anyone could make this work


Thanks

r_adical is offline  
Old 10-03-2013, 08:12 PM
  #4  
Boboeing
 
Join Date: Sep 2011
Location: Doylestown, PA
Posts: 63
Likes: 0
Received 0 Likes on 0 Posts
Default

I have a VVRC 40cc Twin that weighs 4 oz more than the DLE 35 RA that I would like to put into the 35cc Extra 300. If it works with the DLE 35 it should be ok with the 40cc Twin. My only concern is fit inside the cowl. The engine width from spark plug cap to spark plug cap is 8 inches.
Boboeing is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.