ANT Netherlands SOftware and Windows 7
 

Anyone out there running AMT Netherlands Software in Windows 7?

I can get the program to run but when I attempt to connect to the ECU for an Olympus I get a lost signal error message (presumably due to loss of signal from the USB-serial port connector that runs through Com3).

I am not very PC savy and don't know how to work through this problem.

Phil

RE: ANT Netherlands SOftware and Windows 7
 

Hello.

I had a simulair problem with windows XP but after downloading new drivers for my usb-serial port connector, all was ok.
Hope it helps.

RE: ANT Netherlands SOftware and Windows 7
 

Thanks Didier,

The drivers were the problem - there was a conflict amongst USB-serial adaptor drivers that was easily fixed.

The software works with Windows 7

Phil

RE: ANT Netherlands SOftware and Windows 7
 

I have this problem also. Can you please let me know where I find the newer USB-serial adaptor drivers for XP?

Thanks

RE: ANT Netherlands SOftware and Windows 7
 

ogm,

You need to use drivers for the chipset in your particular adaptor, doing so requires that you go to the web site of the manufacturer of your adaptor (in my case it was commfront.com). I first used a Belkin adaptor but it turned out not be compatible with Windows 7.

Too bad Bennie doesn't make software that works on a Mac - this would be easy.

Good luck,

Phil

RE: ANT Netherlands SOftware and Windows 7
 

Hi Phil

I connected the 3 Futaba cables to the wrong pins on the serial port. It is working now. Manual do not provide any help on how to setup initial parameters , etc, etc. When I go to the Trust Management tab and change to Pegasus, software do not keep my settings. How you use this software?

RE: ANT Netherlands SOftware and Windows 7
 

Hi guys,

Perhaps one of you can tell me what the speed setting is for the comport?

Thanks,

JanR

RE: ANT Netherlands SOftware and Windows 7
 

Hi,

Baudrate is 2400.

<br type="_moz" />

RE: ANT Netherlands SOftware and Windows 7
 

Ray, <div>I've sent an email for you regarding problems I  am having with an 2.0 ECU.</div><div>I would appreciate a lot if you could help me</div><div>
</div><div>Thanks,</div><div>
</div><div>Jones</div>

RE: ANT Netherlands SOftware and Windows 7
 

Hi Everybody,

New version of TMC application will be available on AMT website next week. It special build for smaller notebooks (10")

Regards,

Ray Struik
AMT Netherlands

RE: ANT Netherlands SOftware and Windows 7
 

Ray,<div>Did you receive my e-mail? If not, I can send It as a PM.</div><div>Thanks,</div><div>
</div><div>
</div><div>Jones</div>