H9 Edge
 

Hi,

Any thoughts out there on using Futaba S9101 servos for the elevator on a H9 Edge 540? I have converted my edge to use one servo per elev half mounted in the tail. I'm powering the machine with a Moki 1.8 . I actually flew the machine last year a few times, but this year I'm looking at trying a few 3d moves. I guess I'm getting paranoid - this is not a metal geared servo. :confused:

Here are the specs on the servo at 4.8v - I'm using 6v NiCd:

S9101 Coreless BB 41.7oz/in

High speed; water resistant; gold plated connectors


Thanks,
Mike

H9 Edge
 

Guess I'll just give it a go...

H9 Edge
 

That should be enough. A few guys are using the hitec mini 225bb servos for the elevator. I've decided to use a y rod with a hitec 645-107 oz. in torque on 4.8 volts

H9 Edge
 

The manual recommends 50 in/oz for standard flying
and 90 in/oz for 3D flying.

H9 Edge
 

Combined at 6v I should have better than 100oz/in, but I was concerned about the nylon gears vs meal gears. Probably just paranoid BUT it could be good thinking. :-)

Thanks for the replies.

H9 Edge
 

I put JR 8101's in mine with plastic gears.
The manual shows them installing JR 531's which are plastic.
That is a good question that I didn't think about!
The one good thing about plastic is that it doesn't vibrate the screws out as bad as metal.

H9 Edge
 

test

H9 Edge
 

That servo will be fine.
If in doubt, go to a 5 cell pack