What servos in ultimate?
 

I have ordered a CG 10-300ARF, I would like to know what servos to use in aeilerons and use 2 or 4 servos....also any other changes or tips that need to be done to save me trips to the hobbyshop (not that that would be so bad either;))Please advise.
THX..Kevin

RE: What servos in ultimate?
 

Anyone??? Surely someone in the "Universe" has an idea?

RE: What servos in ultimate?
 

I have an answer for ya. I do not have the ARF, but I did build the kit. I had to modify it for two servos. I do not know if the ARF is set up for four servos. I am using two Hitec 945MG for each pair of ailerons.

Andrew

RE: What servos in ultimate?
 

THX Andrew, thats a start. Is there anything else I should do this is my 1st Bipe. I consider myself intermediate(aerobatics, basic 3D). Not sure what to expect and want to fly it hard without mechanical failure.

RE: What servos in ultimate?
 

It is set up for two aileron servos, which are sufficient. If you intend, as you say, to fly it "hard", then I would go a step above standard servos; on ALL surfaces.

Mine has Futaba 9252 digitals on elevator and aileron; not because I think the strength is needed, but because I have come to prefer the precision of digitals.

There is a picture of mine, along with a few modifications I did that I believe are necessary, on another thread here someplace. I'll try to find it...

.

RE: What servos in ultimate?
 

Here it is...



http://www.rcuniverse.com/forum/Carl...1463671/tm.htm

.

RE: What servos in ultimate?
 

Thx Steve, I actually had done some searching here and seen your mods already...raising some questions for me. I like what you had done. I was a little concerned over the aileron servos, read somewhere that one in each wing was best, I think I will go with some Hitech heavy duty on all but throttle, and maybe beef up the connecting rods on ailerons.
Again THX for replying, Kevin