laser 200
 

Got my new Pacific aeromodel laser 200 Arf today from Chief Aircraft.I was suprised to see it today because its Sat.Very nice ARF.Well packed. Nice covering.Any seggestions?What servos?(futaba)The inst. calls for thin CA to attach the elev. to the fuselage.Would it not be better to use epoxy?The elev. fits into a very tight slot in the fus.How would you keep CA off the covering??Thank very much. Jim.

RE: laser 200
 

Hi Jim,
If the fit is real close I wouldn't be hesitant to use CA.
You could wick some thin CA in, and wipe any CA that gets on your covering
with a paper towel.
Then after it's dry use a paper towel soaked in acetone to remove any remaining CA
on your covering.
Bob