gee bee arf question??
hi i have one of the great planes gee bee arf,s and in the manual it says there are marks on the aft.fuse. for the control rods to exit - but on my arf there are no marks can some one give the locations in inches from the bottom & rear of the fuse. for both the elevator & rudder - i know i can just guess but it would be nice to have the correct info
thanks tlg |
RE: gee bee arf question??
If I remember correctly, mine had little dimples molded into the fiberglass.
Not "marks" as such, as would be drawn with a pen or pencil. |
RE: gee bee arf question??
that is what i was hoping for but no marks on outlines on dimples it is just smooth
thanks for the reply tlg |
RE: gee bee arf question??
With my Gee Bee only the right side had the marks for the rods to exit through. Look carefully against a light and you'll barely see them. For the left side, simply match the front exit of the right side.
|
All times are GMT -8. The time now is 12:34 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.