Seagull Laser with G26 ????
 

Hey guys
I've read all the post on this plane with other engines but have not heard how it flies or holds up with the g26. I know someone is flying this setup or at least tried it. I'm just getting back in the hobby after being out for 3 1/2 yrs. I now fly the dragon lady with a OS FS 120 pumper. I fly a lot so I'm looking to get away from the high $ glow fuel. I've seen the seagull laser 200 fly with a OS 160 two stroke and flew very well. Only have the cash to build one new plan for this season. Should it be this plane with the g26?
Thanks
Joe

RE: Seagull Laser with G26 ????
 

Yes of course use the G26 if you want to 3D and also save $$$ on fuel, the G26 has about the same output as the OS160FX. Think you G26 will throw a 18x8 whilst the 160 about an 18x6. My 1/4 scale Laser is about 10 lbs with a TT120 and the verticals are very very nice. Go for the gasser.

RE: Seagull Laser with G26 ????
 

some were in that thread they was talking about it shaking the plane apart

RE: Seagull Laser with G26 ????
 

MVVS 160 gasser perhaps?

RE: Seagull Laser with G26 ????
 

Try first your dragon lady with gas engine. It was done somewhere here at RC online.