GP 202 Control throws
 

I am just trying to set up my GP 202 control throws. Could someone please tell me that the throws recommended are correct for the elevator.

5/16 up

7/16 down


Thanks Guys, Harry

GP 202 Control throws
 

Harry,

I just finished the GP Giles .46 kit. It's 1/2" up and down.

I also have the GP Giles 1/4 scale ARF that I haven't started, but the manual shows what you indicated.

You can also look at the Great Planes site:

http://www.greatplanes.com/techsupport/technotes.html

GP 202 Control throws
 

Thanks ed,

Sure doesn't look like much but that's what I'll go with.

Again thanks for your time, Harry

GP 202 Control throws
 

It doesn't take much throw for the Giles.
My high rate is the recommended low rates in the manual!

GP 202 Control throws
 

If this is the 1/4 scale Giles, I would recommend that you reduce the throws to 1/4 up and 3/8 down. The elevator is VERY sensitive. A lot will depend on where your CG is. If it is as stated or aft then follow my recommendations. If it is forward, then the book may be close.

GP 202 Control throws
 

Thanks so much Geistware,

Yes it is the 1/4 scale and I will start out with the throws you recommended.
I've been flying r/c for 34 years but still am willing to learn from others experiences.

I appreciate your time tremendously, Harry

GP 202 Control throws
 

I agree with Geistware. Be very careful with that elevator. I had several of these .I finally got one where I could enjoy it(Quadra 35 gas) and I ran out of gas and had a bad landing.That plane can be a little twitchy some times.1/4" or maybe 5/16" on the elevator at most. good luck!

GP 202 Control throws
 

Thanks Danny I'll give it a go.

Harry

GP 202 Control throws
 

Let us all know how you do.

GP 202 Control throws
 

Will do fellas as soon as the weather and job resposibilities allow me the time.

Thanks so much friends, Harry