RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   ARF or RTF (https://www.rcuniverse.com/forum/arf-rtf-75/)
-   -   edge 540 engines (https://www.rcuniverse.com/forum/arf-rtf-75/329351-edge-540-engines.html)

zagiman-RCU 10-24-2002 01:20 PM

edge 540 engines
 
Does anybody know of a good engine to use in the edge 540 .60. I already have an O.S. .61 Will that be sufficient power. Has anybody flown one yet. Thanks

rcpilot_971 10-25-2002 03:30 AM

motor for 540
 
if you are using a two stroke OS 91 FX or OS 108 FX

four stroke YS 91 or saito 100

DGrant 10-25-2002 04:52 PM

edge 540 engines
 
If it's the Aeroworks Edge 60/90, I'd say YS120. I've flown them with a OS .91FX 2-stroke, and also with a YS.91 4-stroke. Of these the one with YS performed very well, although it might could use a little bit morel. The one with the OS definately needed more though.
I think one of these with a YS 120 would be radical. :eek:

Some of it might depend on your experience level too. If your wanting all out unlimited(YS120), or a good aerobatic plane that you can grow with go with a smaller 2-stroke.

Although a 61FX would fly the plane, I think it merits more engine then that.

This was my experience with the plane, as I've been a test pilot of 2 of these so far, and had opportunity to shake them out a bit.
An owner might have a different opinion though. I hope this helps. :)


All times are GMT -8. The time now is 08:11 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.