Pulse XT40 Wings
 

Just bought a hangar 9 Pulse and I joined the wings together with the wooden dowels and wing tube. Just wondering if anyone recommends putting some epoxy between the wings as well for a bit of extra stability or I also thought of searching around for a couple of more tubes because there is 2 extra slots for what looks to be wing tubes.

Any suggestions would be great

Thanks

RE: Pulse XT40 Wings
 

hello neighbour, i also have a pulse and if you never have to split the wings for transportation then by all means smear a little epoxy in there and join em for good. I have mine stock and fly the heck out of it and have never had a whisper of a problem. good luck and GO RIDERS!!!! lol

Flyboy76

RE: Pulse XT40 Wings
 

Yeah, I just glued mine together. I didn't need to take them apart. Have fun with your Pulse.

RE: Pulse XT40 Wings
 

Thanks for the input guys. What I ended up doing was putting a piece of tape down the middle of the wings (on both sides) and then drilling about 5 holes with a 1/8 bit (did it on the bottom of course). I then took some 45 min epoxy and soaked it in the holes and left it to dry over night and removed the tape. Everything seems to be good and tight.

Thanks once again for the input and happy flying