How to figure out Lipo pack capacity?
I have an Align heli starter that I use for my planes and the Lipo pack I bought does not have a sticker on it indicating the capacity of the pack. The original sales receipt had that info which I used to initially charge the pack, but stupidly I threw it away and never saved the settings in my Accucharger. I want to say it's around 2700mah, 3S1P, 16C. I think I could set the charger to a lower capacity, but don't want to end the charge prematurely. Also, not that familiar with Lipos in general, so not sure that's a good thing to do. Thanks.
|
RE: How to figure out Lipo pack capacity?
Use your charger to discharge down to 3.0v/cell. Then charge it back up and note the amount of mAh put back in.
|
RE: How to figure out Lipo pack capacity?
ORIGINAL: bgosselin Use your charger to discharge down to 3.0v/cell. Then charge it back up and note the amount of mAh put back in. |
RE: How to figure out Lipo pack capacity?
Just set it to something low, like 1A<span style="white-space:pre"> </span>. If it is in fact 2700mAh, it'll take ~2.7 hours (162 minutes) to charge.<div>
</div><div>If you know it's at least 2000mAh, set the charge rate to 2A. That will take close to 90 minutes to charge if its a 2700mAh pack.</div><div> </div><div>And so on. Just make sure any safety timer is shut off on your charger...</div> |
RE: How to figure out Lipo pack capacity?
Got it, thanks.
|
All times are GMT -8. The time now is 06:02 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.