TIP: when zero'ing out your ailerons...
12-31-2004 | 08:26 PM
#1
Thread Starter
Senior Member
Joined: Nov 2003
Posts: 739
Likes: 0
Received 0 Likes
on
0 Posts
From: Martinsville,
IN
TIP: when zero'ing out your ailerons...
When installing new equipment on a new plane, and you are zero'ing out your ailerons.... make sure you have flaperons TURNED OFF !!!!
wasted about an hour today...LOL
Flaps were set to about 3/4 flaps and when I hooked up the Y harness on chan 1, I had forgot I was messing with flaperons. What a mess
Just some FYI
wasted about an hour today...LOL
Flaps were set to about 3/4 flaps and when I hooked up the Y harness on chan 1, I had forgot I was messing with flaperons. What a mess
Just some FYI
12-31-2004 | 11:58 PM
#4
Member
Joined: Aug 2004
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
From: Marsh Harbour, Abaco, BAHAMAS
RE: TIP: when zero'ing out your ailerons...
I had a similar experience, I just bought a Futaba 3CAF and was programming in my settings
into the TX and it seemed as though all my settings were messed up until I realized the flap
knob was turned.
into the TX and it seemed as though all my settings were messed up until I realized the flap
knob was turned.
