DesignCad 3D Max 15
 

Hi,

I just got Cad and I'm having a problem...most likely Im missing somthing very obvious, but I CANT figure this out. Whenever I'm using the draw line tool and get close to another line, it tries to snap to ethier the ends or middle of the line. I know about using k to snap to a specific part of the line..but all I want to do is draw CLOSE to a line..not snap to it. Is there some way to turn this feature off? I tried avoiding it entirly by using point realative, but when I press the hot key for it...no menu comes up... What am I missing here?

Thx,

The Cad Noob

RE: DesignCad 3D Max 15
 

Well..I did it again...every time I ask a question...I'll find the answer 2 minutes later! [&:] Oh well...at least I know what I'm doing now.