RCU Forums - Arrow 40 Control Throws

RCU Forums (https://www.rcuniverse.com/forum/)

- Beginners (https://www.rcuniverse.com/forum/beginners-85/)

- - Arrow 40 Control Throws (https://www.rcuniverse.com/forum/beginners-85/6057591-arrow-40-control-throws.html)

jvino

07-01-2007 09:21 AM

Arrow 40 Control Throws

I think i'm ready to increase the control throws on my arrow but I noticed that the other two holes in the servo arm are to small. Can I just drill them out to fit or is it not designed to be moved from the factory setting?? Thanks,

Jeremiah

craigpuckett

07-01-2007 11:28 AM

RE: Arrow 40 Control Throws

I used a 1/16 drill bit to open mine up,it works fine with a little more throw.

carrellh

07-01-2007 01:19 PM

RE: Arrow 40 Control Throws

You can use a sharp drill, turned by hand, to enlarge the holes. Most control horns seem have undersized holes. I think it's because there are so many different linkages available they want to be sure the holes are not too big.

All times are GMT -8. The time now is 12:19 PM.