RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Beginners (https://www.rcuniverse.com/forum/beginners-85/)
-   -   leaking engine... (https://www.rcuniverse.com/forum/beginners-85/6063958-leaking-engine.html)

metabolicmaggot 07-02-2007 09:48 PM

leaking engine...
 
had a crash sunday repairable and the guys at the field told me the engine was fine, but didn't bother to start it up. anyway i noticed today fuel dripping off the prop, its coming from the crankshaft, is the bad or is that normal?

bigedmustafa 07-02-2007 09:52 PM

RE: leaking engine...
 
If it wasn't doing it before the crash, then it's probably bad. What kind of engine is it and what kind of glow fuel mix are you running it with?

metabolicmaggot 07-02-2007 10:03 PM

RE: leaking engine...
 
its a GP 42 running 15% coolpower and I don't think it did it before, still seems to have the same good compression. has anyone else had an engine do this?

horace315 07-02-2007 10:20 PM

RE: leaking engine...
 
did you empty the fuel tank after the crash?if not you might want to check the crankshaft being bent.if you left fuel in it that might be filling into the carburator and leaking out from there

downunder 07-02-2007 10:33 PM

RE: leaking engine...
 
I agree with Horace you probably had fuel left in the tank and may have stored the model nose down. There's nothing to stop fuel running out the front of the crankshaft other than the very small clearance between the crankshaft and the crankcase. It's quite normal even for a ball raced engine but I think yours is plain bearing in which case you shouldn't be using Coolpower fuel. Plain bearing (bushed) crankshafts need at least 20% oil and the more castor the better. Ideally they need 22% all castor for very long life.

metabolicmaggot 07-02-2007 11:32 PM

RE: leaking engine...
 
I just use the fuel I was told to use. I emptied the fuel out but there was that little bit that is hard to ge out.

jetmech05 07-03-2007 04:02 AM

RE: leaking engine...
 
is there any more play, side to side, in the crank shaft than before the crash? If so you probably got the front bearing, should be replaced.
what kind of crash did you have? Nose down?

piper_chuck 07-03-2007 06:44 AM

RE: leaking engine...
 

ORIGINAL: metabolicmaggot

I just use the fuel I was told to use. I emptied the fuel out but there was that little bit that is hard to ge out.
As a rule of thumb, I always run an engine dry at the end of the day. This way, there's no methanol or nitro in the engine to cause rust. If I can't run it dry, I'll pull the fuel line and make sure I empty as much fuel out of the engine as I can and then add some after run oil. If I have the misfortune of crashing, I make time when I get home to clean and inspect the engine so I don't put it away with fuel inside.

opjose 07-03-2007 02:19 PM

RE: leaking engine...
 
And this prevents the accidental dripping of fuel onto your floors or carpets.



All times are GMT -8. The time now is 08:06 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.