Changing Reciever in Nexstar
 

how hard is it to change the reciever in the hobbico nexstar getting ready to buy the Dx7

RE: Changing Reciever in Nexstar
 

it's not hard at all, just pay attention to where all the wires go. and when your done, go ahead and check the c.o.g.

RE: Changing Reciever in Nexstar
 

Piece of cake. Just follow the directions that come with the radio/reciever.

RE: Changing Reciever in Nexstar
 

OK well i guess what i was also tring to ask is where is the reciever is it under the 3 servo's????

RE: Changing Reciever in Nexstar
 

You can change the location of the receiver without causing problems. In fact, because of the configuration of the DSM2 receivers you will more than likely have to improvise a little bit. This is because these receivers are made up of two parts connected by a wire. But don't lose any sleep over it because there is plenty of room inside of the fuselage to mount the receiver.

Ken

RE: Changing Reciever in Nexstar
 

yes very simple, just be sure to check cg, and control movement, when you are done