RCU Forums - Tx flap switch question

RCU Forums (https://www.rcuniverse.com/forum/)

- Beginners (https://www.rcuniverse.com/forum/beginners-85/)

- - Tx flap switch question (https://www.rcuniverse.com/forum/beginners-85/9161900-tx-flap-switch-question.html)

brett65

10-10-2009 01:49 PM

Tx flap switch question

Is it possible to put my flaps on a switch rather than the turn dial on my 7C? I would like to use the 3 position switch, but can't seem to figure out a way or find one in the manual. Thanks!

Dsegal

10-10-2009 02:28 PM

RE: Tx flap switch question

Go to www.futaba-rc.com/ click on FAQ, Airplane Programming, No. 13. You will use the Airbrake function, but I think it can only be done on a 2-position switch.

oldvet70

10-10-2009 05:41 PM

RE: Tx flap switch question

From Bax in the Futaba Forum:

You can assign channel 5 or 7 to be operated with switch G, which is a 3-position switch on the 2.4 GHz FASST 7C transmitter. That will give you three flap positions: up, 1/2 down, full down.

brett65

10-10-2009 09:49 PM

RE: Tx flap switch question

Quote:

ORIGINAL: oldvet70

From Bax in the Futaba Forum:

You can assign channel 5 or 7 to be operated with switch G, which is a 3-position switch on the 2.4 GHz FASST 7C transmitter. That will give you three flap positions: up, 1/2 down, full down.

Sweet, I didn't even think about plugging into channel 7 since I had the battery there. Can you tell this is my first plane over 4 channels?:)

All times are GMT -8. The time now is 09:29 AM.