Notices
Brushed/Brushless motors, speed controls, gear drives Discuss all aspects of brushless motors, brushed motors, speed controls (ESC's), gear drives and propellers in this forum.

Exceed ESC problem

Old 10-24-2010, 10:12 PM
  #1  
Junior Member
Thread Starter
 
Join Date: Oct 2010
Location: houston, TX
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Default Exceed ESC problem



Hi Everyone
I just bought an Exceed RC proton 60A-opto for my brushless electric motor. I have a futaba t9chp super radio, I setup the futaba Tx
to pcm and connect the power to the Esc, I hear the 123 startup and then every second it beepsand keeps beeping. I know this is startup to programing but my collective stick doesnt respond at all. I started the stick at center then up followed by down movement for 3 seconds as the instructions state. But theirs no response, I also tried reversing the radio still no response. Does anyone have an ideas. Im new to this so any help would be greatly appreciated.

Thanks</p>
Old 10-25-2010, 08:32 AM
  #2  
Senior Member
 
Join Date: Jun 2005
Location: Prescott Valley, AZ
Posts: 565
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Exceed ESC problem

Some ESCs require the throttle switch to be set to REV for Futaba.
Old 10-25-2010, 06:40 PM
  #3  
My Feedback: (90)
 
TLH101's Avatar
 
Join Date: Dec 2001
Location: Elephant Butte, N.M.
Posts: 6,716
Likes: 0
Received 2 Likes on 2 Posts
Default RE: Exceed ESC problem


ORIGINAL: jzrf6c

Some ESCs require the throttle switch to be set to REV for Futaba.
Yup, what he said.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On


Thread Tools
Search this Thread

Contact Us - Manage Preferences Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.