Wattage S 3 Viking issues
#1
Member
Thread Starter
Join Date: Dec 2006
Location: Holden,
LA
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
Wattage S 3 Viking issues
Wired up the New motors and didnt have enough power to roll accross the floor? Heres what I have. 2 erc 400BL 1200kv highperformance motors. Two excede rc proton 30A esc and running off a 3s 11.1v 2100mah battery.The esc are tied together with a y lead and plugged into the reciever throttle. The battery power is spluced to have a red and black to both ESC? Any help would be great alot of time and money invested and realy want this one to fly.
#5
Member
Thread Starter
Join Date: Dec 2006
Location: Holden,
LA
Posts: 34
Likes: 0
Received 0 Likes
on
0 Posts
RE: Wattage S 3 Viking issues
Thanx Dr. got it all wired but don't seem like I am getting enough thrust ????? i have the ESC power leads spliced together. OK ? then i have the ESC servo wires running into a y plug to the reciever ? OK i seem to have more power when only one is hooked up. Should I run each motor off a seperate battery and y the throttle to the reciever? Is there a wiring drawing any where to show two esc to one battery. I am fairly new to double motors let alone jets and don,t want to crash this jet. It is a hard kit to find from what I am reading. Any help would be great.
#7
Junior Member
Join Date: Feb 2010
Location: Long BeachCA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
RE: Wattage S 3 Viking issues
EDFs reqiure a much higher kv rated motor in comparison to a regular prop job. You got to remember, you only have a fan(55,70,90mm) trying to provide thrust whereas a propeller for the same size/weight model, you might have 10"/12"/14" prop. Big difference. The way to compensate for that difference, is turn that fan as fast as it'll go!!
Kev