reattaching reciever lead to mystery 60 amp esc
02-26-2009, 07:02 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2006
Location: oratiaauckland, NEW ZEALAND
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
reattaching reciever lead to mystery 60 amp esc
hey all.i managed to tear the reciever lead clean off my mystery esc(don't ask
).its the 60 amp non bec yellow Pentium version.the negative and signal wires are easily re soldered but the power wire ripped its mounting tab clean off the board and i can't see where it goes to reattach it.i was hoping someone could identify where it goes ie the place it resurfaces on the board so i could attach it there
much appreciated
marco
).its the 60 amp non bec yellow Pentium version.the negative and signal wires are easily re soldered but the power wire ripped its mounting tab clean off the board and i can't see where it goes to reattach it.i was hoping someone could identify where it goes ie the place it resurfaces on the board so i could attach it theremuch appreciated
marco
