Falcon 3d brush-less motor
02-08-2010, 05:27 AM
#1
Senior Member
Thread Starter
Join Date: Apr 2007
Location: Schweinfurt, GERMANY
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
Falcon 3d brush-less motor
Hello all,
I have abrush-lessmotorfrom a falcon 3d helicopter (Product #: ATS6043) during a crash the back end of the motor came off. I put it back on. Now it seems that the motor will run for a few seconds then cut back off. it repeats thisuntilthe batt dies. (quiet some time) I was wondering if there is a fix to this. reason im asking is i want to make a boat for my daughter and use this motor for the application. any heli is welcome. thanks
I have abrush-lessmotorfrom a falcon 3d helicopter (Product #: ATS6043) during a crash the back end of the motor came off. I put it back on. Now it seems that the motor will run for a few seconds then cut back off. it repeats thisuntilthe batt dies. (quiet some time) I was wondering if there is a fix to this. reason im asking is i want to make a boat for my daughter and use this motor for the application. any heli is welcome. thanks
