RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   Brushed/Brushless motors, speed controls, gear drives (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/)
-   -   Pinion Gear Help (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/3322039-pinion-gear-help.html)

Allan Aguilar 09-01-2005 11:20 PM

Pinion Gear Help
 
I built an APEX DIY 400 brushless motor with 3mm shaft initially for direct drive application, however, I wanted this motor for a gear drive system. My problem now is, I need a pinion gear that will fit the 3mm shaft. It is difficult to look for this size over the websites I've checked. :D[:@]

Is there anyone who can suggest to me where to buy the Pinion Gear I need that will be mesh with a GWS spur and gear drives ? [:-][8D]

Any help and suggestions will be appreciated. :eek:;):)

Matt Kirsch 09-02-2005 09:20 AM

RE: Pinion Gear Help
 
What sites have you looked at?

Try www.allerc.com.

Allan Aguilar 09-02-2005 01:17 PM

RE: Pinion Gear Help
 
Yeah, I checked with allerc's website, but, I wanted to compare with other on-line sellers. :D:)[8D];)


All times are GMT -8. The time now is 01:24 PM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.