Jeti 70advance opto
Heres the problem I ran into..As I say,Ive got a Jeti70 Advance opto controller and I used the program card to set it up,worked great..Then I tryed changing the setings a few days later cuss I was not the way I wanted,tryed the program card again but when I put the prog card on there was no beep or nothing..Everthing seems to work cuss motor starts run and good throttle controll so is there a way to reset this??
Thank you Thomas |
RE: Jeti 70advance opto
Did you remember to connect a receiver battery to the programming card this time around? The Opto controller needs an external power source to program.
Also, is the motor connected? It won't beep without the motor. |
RE: Jeti 70advance opto
Matt
yes I did it just like thge first time but it wont reprogram or beep after connecting the battery to it..By useing the throttle lever I can set hart timming or brake off on controlleer only.. I dontn know but its a new program card and controller.. One point,mine is the Jeti70 advance 3P opto...Not the plus!Any help !! Iam doing things rite Iam sure Thank you thomas |
All times are GMT -8. The time now is 08:50 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.