RCU Forums - Reversing motor shafts

RCU Forums (https://www.rcuniverse.com/forum/)

- Brushed/Brushless motors, speed controls, gear drives (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/)

- - Reversing motor shafts (https://www.rcuniverse.com/forum/brushed-brushless-motors-speed-controls-gear-drives-123/8315553-reversing-motor-shafts.html)

arichards1969

01-03-2009 11:24 PM

Reversing motor shafts

Hi all,

Can someone tell me if it is possible to reverse the shaft on most makes of brushless outrunners.

Cheers,
ants.

Dr Kiwi

01-04-2009 02:19 PM

RE: Reversing motor shafts

"Many".... maybe not "most", and certainly not "all".

cyclops2

01-04-2009 02:33 PM

RE: Reversing motor shafts

1 Attachment(s)

Not on the BP Hobbies ( Suppo ) H2217-4 .
I am going to take the shaft to a friend to cut a new snap ring groove on the large inner shaft end. The end that was held by a set screw. It needs to be as close to the end as possible. That allows the motor leads to be on the end opposite of the propellor.

Why would anyone want to have to tightly bend back the motor leads ? China still needs some time.

Rich

All times are GMT -8. The time now is 09:03 PM.