Infinity help
 

I am fairly new to the rc field but i have succesfully raced my car for two months now with no real problems, until now.
I was out the other day when it lost power and stalled.On inspection one of the 2 screws holding the carb in place had come loose, and i presume this allowed the mixture to run too lean and hence stall.I must mention at this point that the carb had not come off the engine it was just a little loose, so no dust etc could have got in.After sorting this out i have been unable to start the engine, properly, it does run but for seconds only.
The fuel sytstem is leak proof, compression is fine and i have tried a new glow plug.I have noticed that when i pressurise the fuel sytsem some leaks out at the end of the output shaft just behind the fly wheel.
Could anyone point me in the right direction.
Cheers
Martin

RE: Infinity help
 

try setting all of the needles back to factory settings and try it out. Oh and make sure thosee bolts r on tight and that ther is no airleaks in ur pipes or anything . good luck man , harawong

RE: Infinity help
 

Cheers for the ideas.
Just tried all that still no joy , infact i spent so long at it i had to drain fuel out of the exhaust that had been pulled through the engine.