Pull Starter help
 

I lost three of the four screws that hold the pull starter onto the engine, so i bought some new ones online and put them in. Now when i pull the pullstarter, the cord comes out and doesnt reel back in... help!

RE: Pull Starter help
 

i had the same problem
theres nothin you can do to fix it you have to get a new pullstart for it or convert it to a rotor start which i am trying to find out how to do!

RE: Pull Starter help
 

it could be that you tighten the screws too much

RE: Pull Starter help
 

^^^x1 I hav a pullstart which has the same prob.

{Theblazer5k} I have to loosen the screws a great deal to get mine to work. so much so that I can wiggle it around and fuel gets out of the bottom plese help me also.

RE: Pull Starter help
 

it could be that the pull start needs to be clean or that the string where that nat is rubbing on the back plate(that why i said to lose that screw b/c of the string)

RE: Pull Starter help
 

A simple fix (maybe), it sounds like theres not enough clearance inside the pull start with it done up tight. If you loosen the screws and it magically frees up than this is the problem. Its not ideal to leave the screws loose or the will keep falling out. So get a hold of some thick gasket paper or cardpoard and cut out a gasket the same size the plastick cover and put between it and the backplate. Depending on how tight it is it may take two gaskets.