PORTING CEN MG16 ENGINE
 

I`ve taken out my dremmel and read up a little bit on port polishing, i then ported my liner as shown in pics
put it back togeather and started it up and i feel like the truck revs alot better,

Not content i striped it back down and
took out the con-rod and knife edged and polished it then i went on to the crank and put three grooves on the back of it and done some polishing on it built it up and it now screams and is mental to drive has anyone done this on a cen mg before?
I was going to buy an 18 for it but with this much power from the stock engine i wont have to;)
i was running on odonnell 25% before any porting and could only just about pull wheelies
ive since ran out and have been using odonnell 10% and its lifting the front wheels and riding on the wheelie bar on tarmac!

RE: PORTING CEN MG16 ENGINE
 

that looks real good!;) i hope ya have fun!:D

RE: PORTING CEN MG16 ENGINE
 

Hi sparky 25,
Nice to see someone from Derry on here. Whereabouts do you bash or race?

RE: PORTING CEN MG16 ENGINE
 

Well its hard to find a place but usually around the back yard or ballyronan marina

i really need a bmx track but dont know of any[:@] is there any where in the north of ireland?

if i cant find any where by this summer im going to have to make a track at my house:)