Hawk pro servo install
1 Attachment(s)
Are these items for the servo self tapping scew to fit into for holding the servo to the servo tray? Thanks
|
RE: Hawk pro servo install
Looks like it.;)
|
RE: Hawk pro servo install
They are probably servo plates. The screws go through that, then through the rubber grommet and finally into holes in the plastic frames where the self tapping screws do thier thing.
I've seen models where those are used as a backing plate and form the nut for the self tapping screw though. Take a look at the book that came with your heli it should show a picture even if you cant understand thier version of english. |
RE: Hawk pro servo install
Century has THE WORST manuals!!! [:@]
|
RE: Hawk pro servo install
yep, thats what they are. i used those on my hawk pro and they work but were a real pain. i ended up useing the ones that came with my radio, and they were easy to install.
|
RE: Hawk pro servo install
I ended up using a bunch of lock nuts.
If those work for you, great, but I found them really fiddly to use, and I snapped a bunch open as soon as I tried to tighten the screws. Locknuts are oh so much easier... :) |
RE: Hawk pro servo install
you put them on the backside of the servo frame that is what the self tapping screws bite into for the throttle and collective servos
|
All times are GMT -8. The time now is 01:14 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.