Pacer hinge glue or Gorilla Glue?
I know there is a ton of info on the two but I thought I would ask for a comparison of the two. Which is best for glueing pinned hinges?
|
RE: Pacer hinge glue or Gorilla Glue?
I would use the Gorilla glue if, and only if, I could precisely control the amount of glue I needed for every hinge.
Use too much and it bubbles out at the pivot point and you have a mess. Thats why I use Pacer Hinge Glue. |
RE: Pacer hinge glue or Gorilla Glue?
Gorilla glue for hinge points.Pacer Hinge Glue or epoxy for pinned type IMO
|
RE: Pacer hinge glue or Gorilla Glue?
I really like that Pacer stuff after trying it on my BME Edge 30%. I will probably never use anything else.
|
RE: Pacer hinge glue or Gorilla Glue?
I like the goriila glue bc it fills. I use a scrap piece of 2 56 pushrod to work it around in the hinge opening. Then I lubricte the hinge joints really well with vaseline. Then as the glue dries I just watch to clean up any glue that might ooze out. I have found that any glue that does get out wont set well with the vaseline and all you have to do is flake it off.
|
RE: Pacer hinge glue or Gorilla Glue?
thanks, for this plane I think I'll use the Pacer stuff and I'll experiment with Gorilla Glue on a less expensive project ( if such a project exist :D)
|
All times are GMT -8. The time now is 02:28 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.