E-flite 25 on Pitts model 12
Does anyone have a Pitts Model 12 with the Power 25 BL motor installed? I mounted it per the eflite instructions and it sticks too far out of the cowling. I have 3/4" of an inch between the cowling and the back of the prop. The instructions tell you to use 20mm spacers between the mount and the firewall. Any help would be great.....
Thanks |
RE: E-flite 25 on Pitts model 12
I'm not a real experienced builder, but I had a similar problem. I put eflight .10 on parkflyer cessna skylane 180. The motor stuck out too far to get cowl on. the mount to motor to firewall is wood. I cut the sides off and shortened them keeping the angle the same. I used 3/16 beech a braced the inside with balsa blocks. I used 5 min epoxy on the whole thing and it's strong and tight most important the cowl fits.
|
RE: E-flite 25 on Pitts model 12
Question for all the electric gods.....I have a Eflite power 25 on my pitts currently running a extreme flight 60A esc , a 4350 3s battery and a 12x8 prop. Can I run a 2200 4s battery with a 12x6 prop? Pros and cons?????
Thanks Deniz |
RE: E-flite 25 on Pitts model 12
Question for all the electric gods.....I have a Eflite power 25 on my pitts currently running a extreme flight 60A esc , a 4350 3s battery and a 12x8 prop. Can I run a 2200 4s battery with a 12x6 prop? Pros and cons?????
Thanks Deniz |
RE: E-flite 25 on Pitts model 12
you can always put smaller spacers in or no spacer.
|
All times are GMT -8. The time now is 08:23 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.