cp + problems grounded
 

okay .. first bought it last week 6/18, from LHS .. doing okay for first timer... then the rotor stops switch plugs around come to find out speed contol is bad . call product service.. they send out a new one . everythings going good ,plug in the new speed control no problems .. now it wont get off the ground. read the manual not very good for a newbie.. called again. they tell me to send back to the factory so they can re-set it. tried on my own to mess with the pitch no luck. spins around and around full power. oh yea when i do get it up to full power the green light turns red then back to green ? help

RE: cp + problems grounded
 

Do you have a pitch gauge? You need 5+ degrees of pitch to take off and hover. Are the blades tracking in the same plane. Are the blades spinning clockwise? Are the blades on the correct way?

Nick

RE: cp + problems grounded
 

As for the green light that turns red and back to green under full throttle... that's normal. It indicates a heavy load on the battery. As the charge goes down, this will happen more frequently, then not so much once charged back up.

RE: cp + problems grounded
 

Thanks for the info . the main rotor is turning clockwise and tail rotor is turning counter clockwise. as for the pitch no i dont have a pitch gauge . i put new blades on 6/25 the same way the olds ones came off .and i made sure that they tracking as close to each other as possible. i charged the battery tell the green light went off.