|
blade cx2 swashplate leveling tool
ive been constantly adjusting my swashplate to get the heli to hover so i was wondering does such a thing exist
|
RE: blade cx2 swashplate leveling tool
Yea put me on the list to find out also!!
|
RE: blade cx2 swashplate leveling tool
I don't know why mine is why it is but my swash plate is far from level to get it to hover. It slants forward and to the driver side a bit before it will hold a hover well. When I pulled it out of the box it wouldn't hover. The first thing I did was try to level the swash plate, center the trim on the servos, and then reconnect the servo horns at as close to 90* as possible. It wouldn't stay in the air set like that. Then I followed this site and got it to hover without a problem:
http://www.heli-wiki.com/mediawiki/i..._and_CX2_Setup |
RE: blade cx2 swashplate leveling tool
The way it worked for me was to level the swash as best I could visually, then I adjust for trim from there.
|
| All times are GMT -8. The time now is 02:39 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.