Bat-Safe IS REAL
 

I started a thread earlier that questioned if the Bat-Safe was real or was it a scam. I finally received mine this past week. I must say that it looks to surpass my expectations. Looking at the photos it looks like the old lunch boxes some of us --- uh-- move seasoned fellers used to take our lunch to school in. It is not your old lunch box. It's much larger with double walled construction. It's supper easy to set up and use. I hope to never use it to keep the dragon at bay.

I'll use the ammo box for storage only.

Has anyone heard from Bat-Safe recently? I had ordered one but was told it was on back order. According to their website they expected a shipment "around" the end of May. I have sent them 2 e-mails asking if the shipment had arrived, since it nearing the end of June, but have not received a reply. Anyone have any updated info?

I just ordered one from Hobby King. Have not received it yet, however said it was shipped.

Mark

Bat-Safe info.
 

I ordered two about 2 weeks ago from Bat-Safe.. Nothing yet. I have sent 2 e-mails asking if they were shipped yet.. If so what is the tracking number? I have received no reply from them. Their web site does not list an address or phone number. Do you have either? Also have you received your Bat-Safe yet? Bill Giulian.

Yes I got mine from HK in a very timely manner. In fact I'm using it at this time.

It seems HK's entire supplies in Hong Kong Did you have to pay that high postage from Hong Kong?

Did they call you or e-mail?

Got it from the US warehouse. Shipping reasonable for HK. They were out in the US for some time, I waited till they came in and ordered it from the US.

Thanks Champ. Apparently the US warehouse does not have any currently. And I'm starting to worry that Bat-Safe is out also. They are not responding to my e-mails and they do not publish their address..

Bat-Safe info.
 

Received the two I ordered earlier this week.. They look great. Only difference from instructions is the wire way is already installed in box. Will have to pry open a channel to pull the wires through. Anyone have experience in doing this?

I didn't pry open the gaskets. I removed them and then reinstalled with my wires.

Mark

Mark, Thanks for the help. It worked fine. Bill Giulian