Graupner Micro Nemesis issues...
#151
RE: Graupner Micro Nemesis issues...
My Nemesis
Medusa 12mm brushless 4000kv
ESC CC Tbird-9
TP3S250
Cox 3 x 1-1/4 Prop
Graupner 20mm Spinner
Aileron HS-55
Elevator eflite-S60
Glassed w/ 3/4oz cloth and WBPU & baby-powder filler
Berg Rx
AUW 134 grams 4-3/4 oz
Wont be able to maiden til spring…….
Medusa 12mm brushless 4000kv
ESC CC Tbird-9
TP3S250
Cox 3 x 1-1/4 Prop
Graupner 20mm Spinner
Aileron HS-55
Elevator eflite-S60
Glassed w/ 3/4oz cloth and WBPU & baby-powder filler
Berg Rx
AUW 134 grams 4-3/4 oz
Wont be able to maiden til spring…….
#153
Senior Member
My Feedback: (1)
Join Date: Oct 2005
Location: Fort Worth,
TX
Posts: 1,241
Likes: 0
Received 0 Likes
on
0 Posts
RE: Graupner Micro Nemesis issues...
Looks pretty nice, have you gotten to give it a maiden yet?
Whats the shaft size on the Medusa motors? I could never find a Spinner to fit the Feigaos.
Nick
Whats the shaft size on the Medusa motors? I could never find a Spinner to fit the Feigaos.
Nick
#155
Senior Member
My Feedback: (1)
Join Date: Oct 2005
Location: Fort Worth,
TX
Posts: 1,241
Likes: 0
Received 0 Likes
on
0 Posts
RE: Graupner Micro Nemesis issues...
Lucky! Where did you find them?? I've been searching high and low and havent found a single one.
Todays electronics can be so much lighter, the Nemesis could really perform.
Nick
Todays electronics can be so much lighter, the Nemesis could really perform.
Nick
#157
Thread Starter
Join Date: Oct 2006
Location: Saugus,
CA
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
RE: Graupner Micro Nemesis issues...
Why can't I see my pictures I just uploaded?? Are my new Neme's not worthy of being seen in my own thread??? My thread too good for my own pix? [&:]
#158
Thread Starter
Join Date: Oct 2006
Location: Saugus,
CA
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
RE: Graupner Micro Nemesis issues...
I'll sell one to you if you want... (661)-670-0972 Eric They are just collecting dust and spiders in my shed. The very end pointed tip is broken off one tip on each. They came that way. Easy to fab though. They have the stock 250 and jeti ESC in them. They need servos and linkage set up still. Pick one and contact me if you are interested. They were never finished from whoever built them.