CSM HLG200 Gyro
Hi All,
I've got the following setup: Hitec Eclipse 7 TX GWS 4ch RX GWS 100 Main ESC GWS 50 Tail ESC 370 Main motor Direct Drive Tail Motor CSM HLG200 HH Gyro on a HB chassis The gyro is giving me some grief! I can't seem to get the gain set right, with the gain really low I get really good response to movement but too much tail at 3/4 throttle. At higher gain I get poor response to movement and far too much tail with sporadic bursts of tail motor. If I go really low the tail spins all the time I've heard these gyros can be difficult to setup - any tips? |
RE: CSM HLG200 Gyro
What battery are you using. I've heard that if you use like 3s lipoly it makes the CSM too responsive even with the gain really low....
tomflier |
RE: CSM HLG200 Gyro
Hi Banished,
Make sure all your mixing in that 7 channel tx is disabled for this model (set it up as if for an airplane). It sounds like you have some revo mixing or rudder offset mixing happening. ORIGINAL: Banished Outside Hi All, I've got the following setup: Hitec Eclipse 7 TX GWS 4ch RX GWS 100 Main ESC GWS 50 Tail ESC 370 Main motor Direct Drive Tail Motor CSM HLG200 HH Gyro on a HB chassis The gyro is giving me some grief! I can't seem to get the gain set right, with the gain really low I get really good response to movement but too much tail at 3/4 throttle. At higher gain I get poor response to movement and far too much tail with sporadic bursts of tail motor. If I go really low the tail spins all the time I've heard these gyros can be difficult to setup - any tips? |
RE: CSM HLG200 Gyro
Hi
I'm using a 2 cell lipo. The TX is in Heli mode, I'm sure REVO is off, but not sure off rudder mixing? Should I just turn that off in Heli mode or use plane mode instead? Steve |
All times are GMT -8. The time now is 10:04 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.