tail blades of shogun
 

Recently replaced gears to shogun but I cant remember if the blades in back move in both directins when the tail servo is activated. Right now I move the servo rod and the blades move one direction, I pull the rod in the opposite direction and the blades only move enough to be straight with each other. Shouldn't they fold in the other direction?

RE: tail blades of shogun
 

Yes

RE: tail blades of shogun
 

at the ned of the shaft, where the the tail blades are actually connected to the shaft, experiment with moving that in or out a few mm before you find the rifg pitch range, i had that problem too