need help wiring speedcontrols for hummingbird
I want to wire the gws ics50 for tail and the ics100 for main how do I do this for them to work? HELP!!!
|
RE: need help wiring speedcontrols for hummingbird
solder the postive wires from both esc's together, and the negatives together, then put a connector on them like you normally would
|
RE: need help wiring speedcontrols for hummingbird
it won't hurt to have two + inputs to the rx?
|
RE: need help wiring speedcontrols for hummingbird
it won't hurt to have two + inputs to the rx?
|
RE: need help wiring speedcontrols for hummingbird
of course not... one goes to channel 3 for throttle and one goes to channel 4 for rudder (typical setup). If im not mistaken, you can just send the signal wire from the tail esc to the RX and not all three since the main motor esc will power the RX.
|
RE: need help wiring speedcontrols for hummingbird
I thought the tail esc goes to the gyro output and the gyro input to channel 4 of rec.
Do a search on seperates i did see a complete explanation some where. |
RE: need help wiring speedcontrols for hummingbird
Im sorry it was another site I saw the seperate electronicshookup: http://www.helihobby.com/html/separate_electronics.html
|
All times are GMT -8. The time now is 12:50 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.